Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Florissant Homeowners
A broken spring usually announces itself: a loud snap from the garage, a door that suddenly won’t lift, and a car stuck on the wrong side. Garage door spring repair in Florissant typically costs $180 – $340 for one spring, and a matched pair runs about twice that because both springs are almost always replaced together. It’s also one of the most dangerous parts of the whole door. A wound torsion spring holds enough stored force to injure someone badly, which is why we treat spring work as its own specialty rather than a side task. Our technicians have up to 12 years of experience, and we handle the repair in-house. Call (844) 745-3717 with the door’s symptoms and we can often get a technician out the same day. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Garage Door Spring Repair Service Includes
Every spring job is different, but the same six tasks come up again and again. Here’s what each one involves and when a Florissant homeowner needs it.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted horizontally on a metal shaft above the door, and it does the heavy lifting of the whole assembly. When it breaks, the door becomes too heavy to lift by hand and the opener strains or stops entirely. We remove the old spring, match the replacement to your door’s weight and height, and reset the winding to the correct tension so the door balances properly. We work on the door you have, whether it’s a Clopay, Amarr, Wayne Dalton or an older setup whose spring has clearly been replaced before.

Extension Spring Replacement
Extension springs run along the horizontal tracks on either side of the door and stretch as the door closes. They’re common on older doors, and when one lets go it can whip toward anything nearby. We replace them in matched pairs, install the safety cables that keep a broken spring contained, and check that both sides are pulling evenly. If your door has that older spring style, it’s worth having it looked at before it fails.

Broken Spring Repair
A broken spring shows up as a door that opens a few inches and stops, a loud bang you heard from another room, or a gap in the coil you can see from the floor. We confirm which spring failed, check whether the other one is close behind, and replace what’s needed. We don’t wind a broken spring back into service or patch it. A failed spring gets replaced, full stop.

Spring Adjustment
Sometimes the spring isn’t broken, just out of tune. A door that drifts down on its own, feels heavier than it used to, or slams at the bottom often needs its tension adjusted rather than replaced. We measure the door’s balance, adjust the winding to spec, and test the door by hand before reconnecting the opener. Proper adjustment takes load off the opener motor and makes the door safer for everyone in the house.
Safety Cable Installation
Safety cables are the steel cables that thread through an extension spring so a break stays contained instead of flying loose. Many older doors never had them installed, and some have cables that are frayed or rusted through. We fit new cables rated for the door’s weight and check the attachment points at both ends. If you have extension springs and no cables, this is a cheap fix that removes a real hazard.
Spring Inspection
Not every call ends in a repair, and that’s fine. An inspection checks the springs for rust, gaps and uneven wear, looks at the cables and drums, and tests how the door balances. Florissant’s freeze-and-thaw winters work metal hard, and springs that sat through a cold snap can be closer to failing than they look. We tell you what we find and what, if anything, needs doing. No replacement pitch if a repair will do.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
Springs are springs, but the door around them isn’t. A Raynor door and a Clopay door carry different spring setups, different drum sizes and different weight distributions, and knowing that up front saves diagnostic time. We’re factory-familiar with LiftMaster and Chamberlain openers, which means when a spring lets go we also know how that specific opener handles the sudden change in load and whether it needs a travel-limit reset after the repair. That’s the difference between a technician who has to figure out your door on your driveway and one who already knows where it wears out.
We also service Genie systems and the older Craftsman openers plenty of Florissant homes still run, including the chain-drive models that have been in garages for years. Same story on the door side: Amarr and Wayne Dalton panels, Clopay steel doors, Raynor commercial-style hardware. Whether you have LiftMaster, Chamberlain, Genie or any other make, we can help. Our technicians have up to 12 years of experience across those brands, so the diagnosis usually happens fast and the right parts get ordered once.
Signs You Need Garage Door Spring Repair Right Now
Springs rarely fail without warning. Most give some kind of sign first, and catching it early is cheaper than catching it after the fact.
- A loud snap from the garage. That bang is usually the sound of a torsion spring breaking, not the door itself. If you heard it, don’t run the opener again until someone looks at it, because a door with one broken spring can twist and jam in the tracks.
- The door opens a few inches and stops. This is the classic broken-spring symptom. The opener is trying to lift weight it was never designed to carry alone, and running it repeatedly can burn out the motor on top of the spring cost.
- A visible gap in the spring coil. Look at the torsion spring above the door. A clean break leaves a gap you can spot from the floor with the door closed. Don’t reach up to touch it; just note it and call.
- The door feels much heavier than usual. If you can lift the door by hand and it takes real effort, the spring isn’t doing its share. A properly balanced door lifts with one hand and stays put halfway up.
- The door slams down or drifts on its own. A door that won’t stay open at the halfway point has lost tension, and a door that closes too fast is a hazard to anything underneath. Both point to spring adjustment or replacement.
Our Garage Door Spring Repair Process – Step by Step
- 1
Phone diagnosis. We ask what happened, when, and whether the door is stuck open or closed. That tells us what to bring, so the first visit is often the only visit. Call (844) 745-3717 and we’ll book the closest opening, with same-day service when the schedule allows.
- 2
On-site safety check. Before anything else, the technician secures the door, checks the tracks and cables, and confirms which spring failed. If the door is hanging or the cables are compromised, that changes the plan before any winding starts.
- 3
Written estimate before work. You get a clear price for the repair, quoted and agreed before any work starts. If a pair is needed rather than a single spring, you’ll see that in the estimate, along with why. No surprises on the invoice.
- 4
Repair with the right parts. The old spring comes off, the new one goes on, and the winding gets set to the door’s actual weight. We test the door by hand at several points to confirm the balance before the opener gets reconnected and its travel limits get reset.
- 5
Final walkthrough. The technician runs the door a few full cycles, checks the rollers, hinges and cables, and shows you what was replaced. If anything else is close to wearing out, you’ll hear about it plainly, without pressure to fix it that day.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Florissant?
A typical spring repair in Florissant runs $180 – $340 for one spring, and that’s the number homeowners ask about first. A matched pair usually gets replaced together, so a pair costs about twice that range. Here’s how the pricing usually breaks down:
| Scenario | Typical estimated range |
|---|---|
| Single torsion or extension spring, replaced | $180 – $340 |
| Matched pair replaced together | About twice the single-spring range |
| Spring adjustment only (no replacement) | Quoted per job by written estimate |
| Safety cable installation alongside a spring repair | Quoted per job by written estimate |
| Cable repair, if a cable failed with the spring | $130 – $250 |
What affects the price: the type of spring (torsion springs generally cost more than extension springs because of the winding work), whether one or both springs need replacing, the door’s size and weight, and whether any cable or hardware damage happened when the spring let go. A door that ran on a broken spring for days can also need track or roller work, which is priced separately.
How to avoid overpaying: ask for the estimate in writing before anything gets touched, and ask whether the price is for one spring or a pair. Some lowball quotes cover a single spring when the door clearly needs two, which is how a “cheap” repair turns into a second bill a few months later. Our estimates are free, and the written estimate sets the final price, quoted and agreed before any work starts. Call (844) 745-3717 for an exact quote.
Garage Door Spring Repair Near Florissant – Our Service Area
We connect Florissant homeowners with local garage door professionals, and the surrounding north-county area is well covered. That includes Old Jamestown, Hazelwood, Ferguson, Bridgeton, St. Ann, Bellefontaine Neighbors, Jennings, Spanish Lake, Overland, University City and Maryland Heights. If you’re in Florissant proper or anywhere nearby, the same crew can usually reach you the same day. For neighboring towns, here’s the relevant garage door spring repair page, and if you want the main overview of who we are, start at Florissant Garage Door Repair Pros. Same-day service depends on the day’s schedule, so a quick call gets you the soonest slot.
Serving Florissant, MO – Our Local Coverage Area
We serve Florissant and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Florissant
Garage door spring repair is replacing or re-tensioning the springs that counterbalance the door’s weight so the opener doesn’t carry it alone. Springs are high-tension parts under serious load, and this isn’t a job to attempt without the right winding bars and training. We handle torsion and extension springs in-house, matched to your door’s weight and size. Call (844) 745-3717 and we’ll talk through what’s happening with your door.
Most single-spring repairs are done in about an hour to 90 minutes once the technician is on site, and a pair takes a bit longer because of the rebalancing. The visit also includes a test cycle and a check of the cables, rollers and opener travel limits. The exact timing depends on the door and whether anything else needs attention. Call (844) 745-3717 for a time window.
Spring repair in Florissant typically runs $180 – $340 for one spring, and a matched pair runs about twice that because both springs are usually replaced together. Cable repair, if a cable failed at the same time, runs $130 – $250. The written estimate sets the final price, and it’s quoted and agreed before any work starts. Call (844) 745-3717 for an exact quote; estimates are free.
Yes. We’re factory-familiar with LiftMaster and Chamberlain systems, along with Genie, Raynor, Clopay, Amarr, Wayne Dalton and Craftsman. A broken spring puts a sudden load change on the opener, and knowing how a specific model handles that saves time on the reset after the repair. Our technicians have up to 12 years of experience across those brands.
Same-day service is often available, and emergency garage door service is a core part of what we do, not an add-on. Call (844) 745-3717 and we’ll book the closest opening; we answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside those dispatch hours gets booked into the next opening.
We stand behind the work with a satisfaction guarantee, and the specific coverage depends on the parts used and the job, so ask the technician to walk you through it before the work starts. The written estimate spells out what’s being replaced and what’s covered. If something isn’t right after the repair, call us back and we’ll sort it out. Call (844) 745-3717 with any warranty questions.
Clear the floor in front of the door and move anything hanging near the tracks, then leave the door closed if it’s stuck and don’t run the opener. If you heard a snap, leave the door alone until the technician arrives, and keep kids and pets away from the garage. Have your door’s brand and any opener model info handy if you can find it. Call (844) 745-3717 to confirm your appointment.
Schedule Your Garage Door Spring Repair Service in Florissant Today
A broken spring doesn’t get better on its own, and running the opener on a failed spring can turn a $180 – $340 repair into a bigger bill. We’ll give you a written estimate before anything starts, do the work right, and skip the replacement pitch if a repair will do. Call (844) 745-3717 for a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Florissant Garage Door Repair Pros.